0 Items
Follow us on Twitter.
Be a fan on Facebook.
Home » How-To Guides » Studded Duct Tape Bracelet
DIY VideoStudded Duct Tape Bracelet
Gather materials.
Rip off a piece of duct tape that will fit around your wrist. Make sure to leave a little extra space for the velcro/snap overlap.
Fold over one side as shown.
Fold over the other side as shown.
This is what the duct tape should look like. Now begin laying studs down. This is just for show, so that you can see what your bracelet will look like.
Once you know where you'd like the studs, push them through the duct tape one at a time as shown.
Fold the prongs into the middle so that the stud is in nice and sturdy.
Continue studding your bracelet as shown...
This should be enough...
Here is what the back will look like.
We took narrow/long pieces of duct tape and covered the back of the bracelet. This will prevent your skin from getting itchy.
We used snaps, so we prepared our snaps. A hammer is needed as well. We recommend velcro as well, either works :)
Once we got the snaps on, I tried it on!!
Everyone at NYDS is ooooing and ahhhing over this bracelet! It's SO fun and SOO easy :)
Another view...
